Sobre este proyecto
design-multimedia / 3d-models
Abierto
Contexto general del proyecto
I'm a professor in a local university and I need a 3D design and render with animation of an old design of energy generation for my class See the attached image 1. The waves (light blue area) must move from left to right and the time between the crest and the valley (highest and lowest part of each wave) must take 4-5 seconds and the height difference between them must be 1 meter. 2. The open vertical rectangles (Pillars) are 18" pipes open in the bottom side and sealed in the top. 3. Each pillar will have 2 Check Valves (Left diagram) one of them will let the air to enter and the other will let it exit the pipe. See the small green arrows to put the direction of each valve. The flow of ir must be "Injected" into the 2 main horizontal pipes in a 65 degrees angle to accelerate the air flow inside the 2 main pipes. 4. The circles in the right must be replaced by a design of a Pelton Turbine (in the internet there are some open designs) and a generator. You must change the inflow and outflow design of the case where the pelton turbine is installed to match the other design included below the image. The outflow must be redirected (may be with a curved pipe) to the main pipe. 5. Include an animation of: a) Waves b) The air flow inside the main horizontal pipes c) The pelton turbine spinning d) If possible, the opening and closing cicle of the check valves every time the water level goes up and down inside of each pillar. Add the arrows to indicate the flow of the air entering and exiting the pillars.
Categoría Diseño y Multimedia
Subcategoría Modelos 3D
¿Qué necesitas? 2 a 6 piezas
¿Es un proyecto o una posición? Un proyecto
Disponibilidad requerida Según se necesite
Plazo de Entrega: No definido